Home › Services › Sensor Repair
Geneva, IL · Safety systems

Garage door won’t close? It’s almost always the safety sensors

If your door starts down then reverses, or just clicks and blinks, the two photo-eye sensors near the floor are the usual culprit. We realign, clean, and replace them, same day.

A garage door that opens fine but refuses to close is almost always the pair of photo-eye safety sensors near the floor. They are the most common reason a door will not close, and in most cases we realign, clean, or replace them the same day.

What your sensors do

Two small units face each other across the bottom of the opening, about four to six inches off the ground. One projects an invisible infrared beam; the other receives it. The moment anything crosses that beam while the door is closing, the opener stops and reverses. Since January 1, 1993, U.S. federal safety rules have required this system on every residential opener.

Signs the sensors are your problem

  • The door goes down a few inches, then reverses back to fully open.
  • The door will not close from the remote or wall button, only clicks.
  • The opener light or a sensor LED blinks when you press close.
  • One sensor light is off or flickering while the other is steady.
  • It only happens at certain times of day — a sun-glare giveaway.

What you can safely check first

Sensors are safe to touch — there are no springs involved. Wipe both lenses with a soft cloth, make sure nothing is leaning against the door blocking the beam, and check that both little LED lights are on and steady. If one is out, blinking, or clearly knocked askew, straighten it gently and try again. If the door still refuses to close, that is our cue.

Don’t leave the door open overnight. Call (630) 937-3540 for same-day sensor repair across Geneva and the Fox Valley.

Sensor FAQs

Garage door sensor questions

Why does my garage door open but not close?
The opener sees its safety beam blocked or misaligned and reverses on purpose. Nine times out of ten it is the two photo-eye sensors near the floor being out of alignment, dirty, or hit by sun glare. Realigning or cleaning them usually solves it.
Where are my garage door sensors?
They sit on each side of the door, about four to six inches off the floor, clipped to the vertical tracks. One sends an invisible infrared beam across the opening and the other receives it. If anything breaks that beam, the door will not close.
What do the blinking opener lights mean?
When the door will not close and the opener light or a small sensor LED blinks, the opener is telling you the safety beam is broken or the sensors are misaligned. It is a diagnostic signal, not a burned-out bulb.
Can I still use my garage door if a sensor is broken?
You can force it shut by holding the wall button down with constant pressure, but the auto-reverse safety is off while you do that. Treat it as a short-term workaround and get the sensor fixed, especially in a home with kids or pets.
Do all garage doors have safety sensors?
Every residential opener made since January 1, 1993 is required by U.S. federal safety rules to have photo-eye sensors or a sensing edge. If your opener predates that, it has no auto-reverse and is worth replacing.
How much does garage door sensor repair cost?
Alignment and cleaning is one of our lowest-cost service calls, and a failed sensor pair is inexpensive to replace. See our pricing page for starting prices, or call and we will quote it over the phone.

Door still won’t close?

Don’t leave it open overnight. We fix garage door sensors same-day across the Fox Valley.

(630) 937-3540

Published by Richard Gordon, Reliant Garage Door Repair · Geneva, IL.